Neil,

What application did you find that would copy your necessaries over? If you use Iomega's software it is severely limited in what you can do and I've been hoping to find a better alternative.

Thanks, Rob.

Robb - Pull it out and place it in a plastic bag and then into the freezer for three minutes or so than back into the machine and see what happens.
No, I'm not 'pulling your plonker' - twice I've used this trick and managed to get the data off of a failed unit. True, many times it hasn't worked but in desperate times!!!
The other track I'd take is, if that doesn't work, put it in your other machine as a second disk (in place of the CD probably) and on its own IDE ribbon cable to IDE2. The other machine may pick it up as a D: drive if your lucky and you can then transfer your data onto its drive.


Mr. Wonderfull - The fact that you've a dual processor stopped me answering. That opens up a whole can of worms with the programmes that try to use it. Normally though you should check that your RAM's OK (by substitution), that the video drivers etc are the latest and that it's not something like Kaza running in the background that's freezing it. You may also get a clue if you look in event viewer which may have entries coinciding with failure.
I'd be interested to hear of your experience if you do take it to PC world BTW.

Kayak - will faff around with it today and think about how important the lost data really is. Thanks for your help.

Leo1 - While its in the freezer I will also turn round three times, chuck loads of salt over my shoulder, spit and salute if I see a single magpie and generally hope really really hard. If it works I shall also say out load "Leo1 is an ace cool kid" 10 times :-) Thanks for your response.

Off to find a freezer bag .......

Regards
Rob

Seymour, Its a little ap called backup magic from http://www.moonsoftware.com


Being an idle and simple sod I particularly like this bit;

"Uses simple file copy, does not use any proprietary file formats so you can restore your data without Backup Magic, simply by copying files back to the source location"

Neil

Robb - Good luck - If none of the above work you could try a lightly tapping a corner of the disk on the edge of the desk. Sometimes the plates jam and don't spin up - this may free them. If, of course, you look at the electronic bits and see a hole burnt into an ic then none of the above will work ;-( In that case there are 'shops' that will recover most of your data (usually) but they're very expensive.

Neil, thanks. You're just like me ;-)

Noticed that my PC Plus magazine had a CD/DVD writing software free with it this month which includes a backup facility so might have a look at that. Will report back if it's any good.

For some reason my power lead has stopped powering my laptop. I have about 90 minutes remaining on battery. Is there anything I can do to keep the power going until I can get to shop tomorrow morning?

Thanks.

Mr.E, there's a switch on the wall socket.... :-)

:-) Managed to get another cable to fit, hasn't got a box thingy in between but its working all the same.

Not really a PC question:

My 6 pack isn't working properly..... I have a 6 CD changer in my car. It's now quite old, and won't read the discs very well. Is there anything I can do or is it a specialist job?

Seymour Clearly,

Is that two problems? The first, I would recomend joining a gym, they are quite good at getting 6 packs working :)

J.

I belong to a pretty good BB site, but they've got a problem with their internal email system that loses emails. Anyone got any good ideas I can pass on to them?

BrianTrayda,

You may get a load of emails now, im going to hunt down this problem, and you are my lucky guineapig :)

J.

Hi,

Right, I am having moderate success on tracking this bug down. It is on one of the application servers, and I have logs to trawl through.

J.

Hello,

Re BB Email problem.

Its licked, nailed, sorted, whatever.

It works :)

J.

Jonathan, you're a star. Got 4.

BrianTrayda,

Ill add that star to my collection :)

J.

Help please.
I want to put my Copy of XP pro on another system as well as this one. This will also be connected to the Net.
Ive been told that Microsoft can cut off another machine trying to access the net using the same serial code after thirty days, a feature unique to XP. A load of tosh or True?
I know I will not be able to download updates on the second machine but am perturbed if the above is true.
The things I do too save money!:-)
Iain

Iain - they could only block access to MS sites, there's no MS involvement in your PC accessing, say, AM via Pipex. There has been some talk about future updates disabling systems using security codes known to be shared, but the legal/practical difficulties make this course of action vanishingly unlikely.

the troll,

Unfortunately MS *have* disabled updates on copies of XP that are known to be installed with shared serial numbers.

If it has been installed with some shared codes, then the service packs wont install (and trust me, you *want* the service packs!)

J.